Results 1 to 9 of 9

Thread: 7.62mm x 51mm NATO casing

  1. #1

    7.62mm x 51mm NATO casing

    So I made this in turbocad the other day, it's the brass casing (minus the bullet) of a 7.62 x 51 NATO round, a full sized rifle cartridge.




  2. #2

    Re: 7.62mm x 51mm NATO casing

    And your point is?

  3. #3

    Re: 7.62mm x 51mm NATO casing

    Well no point, this is the forum where we show stuff made in CAD, and this is what I made...

  4. #4

    Re: 7.62mm x 51mm NATO casing

    The casing drawing looks very nice. Don't worry about others on this forum acting superior or arrogant ... sometimes people forget that no one is born with this knowledge and we all had to start somewhere. Keep drawing things and submitting them. The best practice is to find normal things that have unusual shapes and draw them. The Rifle Shell Casing was a good idea... maybe work on drawing the parts in the rifle action assembly next.

  5. #5

    Re: 7.62mm x 51mm NATO casing

    Cool model. I seem to remember hearing that the walls are not constant thickness. So what would be a good way to model that? I don;'t think there is a variable thickness shell option. is there a variable offset entities option?
    I could tell you, but then I would have to kill you

  6. #6

    Re: 7.62mm x 51mm NATO casing

    You would do a solid subtract; make a shape of the 'inside', place it appropriatley inside the casing, then subtract the inside shape. I couldn't find dimensions concerning the inside, so I just left it solid. And thanks for the compliment.

  7. #7

    Re: 7.62mm x 51mm NATO casing

    Looks like a good shell casing to me; one of my favorites, in fact. I have a good .308 target rifle that shoots basically the same cartridge.

    For the variable thickness: I would probably model this as a revolved solid, and just set the thickness in the sketch explicitely.

    Upward and onward...

  8. #8

    Re: 7.62mm x 51mm NATO casing

    Thanks for the compliment; I find in Turbocad doing either the subtraction or revolving works equally well, and taking same amount of time for each method. Thanks guys for the compliments

  9. #9
    Hi, i see this is an fairly old thread, but my suggestion to do this model if you know the thickness is to draw the cartridge profile, both inside and outside profile. Make this a closed sketch. And revolve it around the center axis. Voila and you have a correct cartridge

    Strambo: You are right about the 308. Will just explain the difference. 7.62x51 is the military description of this bullets. And 308 are the civillian description. Exactly the same measurments of these two. The reason iknow these is because i worked for several years in the Norwegian infantery and have been shooting civilian competitions with 308.

    Norwegian armed forces used 7.62x51 nato on their Heckler kock G3 or AG3 as we named it. But a few years ago they switched to 5,56 x 45 NATO that are pretty mutch like 223 . But my knowledge of this cartridge is very little.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •